Home About
Services Services Residential Garage Floor Epoxy Flake Epoxy Metallic Epoxy Garage Floors Garage Floor Restoration Non-Slip Epoxy Floor Residential Concrete Floor Polishing Polyurethane Floors Quartz System Self-Leveling Overlays Sleeper System Floor Outdoor Patio Coatings Terrace Restoration Waterproofing Commercial Commercial Epoxy Flooring Commercial Flake Epoxy Commercial Metallic Floors Commercial Floor Painting Commercial Concrete Floor Polishing Prep Concrete Grinding Concrete Sealing Concrete Floor Prep Chemical-Resistant Novolac Epoxy
Areas Service Areas
Blount County, AL Blount County, AL Oneonta, AL
Calhoun County, AL Calhoun County, AL Anniston, AL Jacksonville, AL Oxford, AL Piedmont, AL
Carroll County, GA Carroll County, GA Carrollton, GA Mount Zion, GA Villa Rica, GA
Cherokee County, AL Cherokee County, AL Centre, AL
Clay County, AL Clay County, AL Lineville, AL
Cleburne County, AL Cleburne County, AL Edwardsville, AL Heflin, AL
DeKalb County, AL DeKalb County, AL Fort Payne, AL Rainsville, AL
Etowah County, AL Etowah County, AL Boaz, AL Gadsden, AL Glencoe, AL Hokes Bluff, AL Rainbow City, AL Southside, AL
Floyd County, GA Floyd County, GA Rome, GA
Haralson County, GA Haralson County, GA Bremen, GA Tallapoosa, GA
Jefferson County, AL Jefferson County, AL Birmingham, AL Clay, AL Fultondale, AL Gardendale, AL Irondale, AL Leeds, AL Mountain Brook, AL Pinson, AL Trussville, AL Vestavia Hills, AL Warrior, AL
Marshall County, AL Marshall County, AL Albertville, AL Guntersville, AL
Polk County, GA Polk County, GA Cedartown, GA
Randolph County, AL Randolph County, AL Roanoke, AL
Shelby County, AL Shelby County, AL Chelsea, AL Columbiana, AL Harpersville, AL Pelham, AL Vincent, AL Westover, AL Wilsonville, AL
St. Clair County, AL St. Clair County, AL Argo, AL Ashville, AL Margaret, AL Moody, AL Odenville, AL Pell City, AL Ragland, AL Springville, AL
Talladega County, AL Talladega County, AL Childersburg, AL Lincoln, AL Sylacauga, AL Talladega, AL
Tallapoosa County, AL Tallapoosa County, AL Alexander City, AL Dadeville, AL Daviston, AL New Site, AL
Gallery Blog Contact
Call · (256) 365-6535
Skip to content
Warm brown stained and sealed floor in a double-height room with a loft rail and ceiling fan
Shelby County, AL

Westover’s concrete floor coatings

Flake, metallic, quartz, polished and sealed floors for Westover homes and businesses. It is about 47 miles from the shop in Anniston, which is a routine run.

What Shanks coats in Westover

A lot of the calls here are older slabs that have never had anything on them, where a grind and seal does more for the room than a decorative system would. It is about 47 miles from the shop in Anniston, which is a routine run.

Shelby County is mostly newer construction, which is the easiest concrete to work with: flat, clean pours that only need a proper grind. The main thing worth checking here is whether a very new slab has actually had its twenty-eight days.

Whatever the slab turns out to be, the order of work does not change: grind it open, repair what is broken, then coat it. The twenty-two systems Shanks installs all sit on top of that same preparation.

Gray and white flake floor in a garage with charcoal walls and two water heaters in the corner

Systems Westover homeowners ask for

Bare concrete slab in a pine-walled barn shop with the roll-up door open and a grinder on the floor

Garage Floor Epoxy

Ground, patched and coated so hot tires and dropped tools do not mark it.

A worker rolling a glossy brown floor coating in an empty white room

Flake Epoxy

Vinyl chip in a pigmented base under clear. The most requested floor here.

Broken brown ceramic tile being pried off a floor beside a painted mural, with a hammer and dustpan

Metallic Epoxy

Pearl pigment moved through resin so the floor reads like poured stone.

Grind and Seal

The concrete you already own, opened up, stained if you want, and sealed.

Patio Coatings

Textured, UV-stable finishes for porches, patios and pool surrounds.

Commercial Epoxy

Shop, warehouse and showroom floors specified for the actual use.

What decides whether it lasts

What repair actually involves

Cracks get chased out into a V with a saw rather than simply filled, so the repair has shoulders to hold onto, then filled with a rigid polyurea that can be ground flush the same day. Spalled edges near a garage door, where water has sat and frozen for a few winters, are rebuilt with a polymer-modified patch. None of this shows in the finished floor, which is precisely why it gets skipped by people quoting the cheapest number.

Moisture is the other half of it

Concrete is not waterproof. On a slab poured without a vapor barrier, or one sitting against damp ground, water vapor moves up through the pores continuously. Put a sealed coating over that and the vapor has nowhere to go, so it collects underneath and pushes the coating off in sheets. This is why a below-grade floor gets tested with a calcium chloride kit or a relative humidity probe before anyone quotes it, and why the honest answer is sometimes a mitigating primer first.

If a grind and seal will serve your room better than a full flake system, that is what you will be told, even though it is the smaller job. The same goes for timing: a slab poured last month is not ready, and coating green concrete is one of the few genuinely unfixable mistakes in this trade. Waiting a few weeks costs nothing; getting it wrong costs the whole floor.

The owner does the work

You deal with the owner from the first phone call to the walk-through at the end. Nobody sells you a floor and then disappears. Taylor Shanks trained with Brian Phillips, The Epoxy Dude, in southern Indiana, and he and Heather have run Shanks Concrete Coatings since 2025. Licensed and insured, Alabama #2602341.

If the honest answer for your Westover floor is a cheaper system than the one you called about, that is what you will be told. More about how Shanks works.

See finished floors

Which floor for which room

Most people call about one system and end up with a different one, because the room decides more than the brochure does. A quick way to narrow it down:

It is outside

A textured patio coating with a UV-stable topcoat. Color choice matters more outdoors than anywhere else, because a dark smooth surface around a pool gets hot enough to be unpleasant barefoot in an Alabama July.

The slab is in rough shape

Restoration or a self-leveling overlay before anything decorative. A coating cannot bridge a surface that has broken down; the slab has to be rebuilt flat first, and then it takes any system you like.

You park a vehicle on it

Flake, almost every time. The chip field hides tire marks and dust, the texture stops it being slick when you track rain in, and the polyaspartic topcoat handles hot tires without softening. It is the most requested floor Shanks installs and it is the right call for the large majority of garages.

It is a finished room you look at

Metallic, if you want the floor to be the feature, or polished concrete if you want it quiet. Metallic gives you flowing depth that no two floors share; polishing gives you the slab itself, refined, with nothing on top that can ever peel.

Read the detail on each system

Other towns in Shelby County

Shanks covers the whole county. If you are between two of these, you are still inside the radius, and the Shelby County page lists every town.

Same barn shop floor finished with a flake epoxy coating

Vincent, AL

40 miles from the shop in Anniston.

Harpersville, AL

43 miles from the shop in Anniston.

Wilsonville, AL

49 miles from the shop in Anniston.

Chelsea, AL

54 miles from the shop in Anniston.

Columbiana, AL

57 miles from the shop in Anniston.

Westover questions

Do you actually work in Westover?

Yes. It is about 47 miles from the shop in Anniston, which is a routine run. Westover is inside the sixty-mile radius Shanks covers out of Anniston, and it is quoted at the same rate as a job in town.

How long will my floor take?

About three to four days for a standard two-car garage: grinding, repair and base coat, broadcast and scrape, then the topcoat. Bigger or more damaged floors take longer, and Taylor will give you the real schedule before starting.

Can you coat a basement here?

Often yes, but below-grade slabs get moisture-tested first. Vapor coming up through concrete will push a coating off no matter how good the prep was, so it is measured rather than assumed.

Will you look at it before quoting?

Always. The condition of the slab is most of the price, so a number over the phone would be a guess. Taylor looks at the floor, then gives you a real number in writing.

What is the most popular floor around here?

Flake, by a distance. It hides dust and tire marks, it is not slick when wet, and it suits both a garage and a finished basement.

Floors in Westover

Square footage, what the room is used for, and what the slab looks like now. That is enough for a real number on a Westover floor.